Categories
 

MidNite Solar

MidNite Solar

MidNite Classic charge controllers offer a host of useful features not found elsewhere. This includes Arc Fault Detection and Ground Fault Protection (GFP) which eliminate the need for a separate GFP breaker assembly.

Three models accommodate solar arrays with operating voltages up to 150, 200, or 250 VDC of operating voltage. A feature called HyperVOC protects the controller from damage when open circuit v exceeds the operating voltage by a margin equal to the battery bank voltage. For example, the Classic150 will operate normally with up to 150 VDC of input, but when used with a 48 VDC battery bank operating at 50 VDC will withstand up to 150 + 50 = 200 VDC. This allows you to maximize array size even when using higher voltage battery systems. The table below represents maximum power only, be sure to consult the power curves in the user's manual when sizing your PV array as allowable current varies with array voltage.

Use MidNite 300 VDC breakers (see Electrical Distribution) for any ower source over 150 VDC. Depending on your load center, a separate MidNite Big Baby Box (see Electrical Distribution) may be needed to accommodate the breaker. On the battery side of the controller, breakers need to be rated for the highest battery charge voltage, breakers rated at 125 VDC or higher can be used for battery banks p to 48 VDC.

Classic controllers have MPPT modes for solar, wind, or hydro with user adjustable power curves, and a learning mode for self optimization. Classics can be stacked to act as one large controller without a separate hub. They have two auxiliary outputs, a dry contact relay and a 12 VDC output. The Classic has built-in Ethernet, USB and RS-232 ports for two-way communications. An internal IP address allows the Classic to directly output operating data to the Internet or a local network without a central server. Each unit also has 32MB of internal memory for data storage.

A built-in wizard covers battery bank size, string voltage, wind turbine selection, power and wire loss, PV breaker sizing and more. Firmware is user upgradable by downloading files. Each unit includes a sealing kit for dusty or salt-air environments, but sealing can reduce output by up to 20%.

The MidNite Graphics Display Panel (MNGP), is a remote duplicate of the LCD on the unit.

Dimensions are 15"H x 6"W x 4"D, and weight is 11.5lbs for all units. The Classic 150, 200, and 250 are Listed to UL 1741 and CAN/CSA C22.2 No. 107.1:2009/09/01 Ed: 3 (R2006) and are covered by a 5-year warranty.

Display: List / Grid
Show:
Sort By:
MIDNITE, CLASSIC 250-SL, MPPT CONTROL, C
MIDNITE, CLASSIC 250-SL, MPPT CONTROL, C ..
$824.18
Ex Tax: $824.18
MIDNITE, CLASSIC 150, MPPT CONTROL, CHAR
The Classic MPPT Charge Controller - 150 Listed by ETL for US & Canada CE Certified FCC Class..
$701.25
Ex Tax: $701.25
MIDNITE, CLASSIC 200, MPPT CONTROL, CHAR
The Classic MPPT Charge Controller - 200 Listed by ETL for US & Canada CE Certified FCC Class..
$701.25
Ex Tax: $701.25
MIDNITE, CLASSIC 250, MPPT CONTROL, CHAR
The Classic MPPT Charge Controller - 250 Listed by ETL for US & Canada CE Certified FCC Class..
$866.25
Ex Tax: $866.25
MIDNITE, CLASSIC LITE 150, MPPT CONTROL,
The Classic Lite 150 MPPT Charge Controller Listed by ETL for US & Canada CE Certified Listed..
$618.75
Ex Tax: $618.75
MIDNITE, CLASSIC LITE 200, MPPT CONTROL,
The Classic Lite 150 MPPT Charge Controller Listed by ETL for US & Canada CE Certified Listed..
$618.75
Ex Tax: $618.75
MIDNITE, CLASSIC LITE 250, MPPT CONTROL,
The Classic Lite 250 MPPT Charge Controller Listed by ETL for US & Canada CE Certified Listed..
$701.25
Ex Tax: $701.25
MIDNITE, MNBTS, BATTERY TEMPERATURE SENS
Remote battery temperature sensor - for use with inverter or charge controller. ..
$22.28
Ex Tax: $22.28
MIDNITE, MNCLIP1.5AC0.8, AC CLIPPER, 1.5
1,500 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The ..
$1,031.25
Ex Tax: $1,031.25
MIDNITE, MNCLIP1.5AC2.0, AC CLIPPER, 1.5
1,500 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper..
$1,031.25
Ex Tax: $1,031.25
MIDNITE, MNCLIP1.5DC0.7, DC CLIPPER, 1.5
1,500 watt DC Clipper for Wind or Hydro designed to work with the MidNite Classic. The Clip..
$1,196.25
Ex Tax: $1,196.25
MIDNITE, MNCLIP1.5DC2.4, DC CLIPPER, 1.5
1,500 watt DC Clipper for Wind or Hydro designed to work with the MidNite Classic. The Clipper..
$1,196.25
Ex Tax: $1,196.25
MIDNITE, MNCLIP4AC0.4, AC CLIPPER, 4KW,
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,237.50
Ex Tax: $1,237.50
MIDNITE, MNCLIP4AC1.0, AC CLIPPER, 4KW,
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,237.50
Ex Tax: $1,237.50
MIDNITE, MNCLIP4AC4.0, AC CLIPPER, 4KW,
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,237.50
Ex Tax: $1,237.50
MIDNITE, MNCLIP4DC0.5, DC CLIPPER, 4KW,
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4DC1.2, DC CLIPPER, 4KW,
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4DC1.3, DC CLIPPER, 4KW,
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4DC12, DC CLIPPER, 4KW, 1
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4DC3.0, DC CLIPPER, 4KW,
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4DC4.8, DC CLIPPER, 4KW,
4,000 watt DC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,402.50
Ex Tax: $1,402.50
MIDNITE, MNCLIP4KAC1.6, AC CLIPPER, 4KW,
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper co..
$1,237.50
Ex Tax: $1,237.50
MIDNITE, MNGP, GRAPHICS DISPLAY FOR CLAS
MidNite Graphics Panel   Size: 4.5"L x 3.75W" x 1"D Boxed: 5"L x 4"W x 2"D Weigh..
$185.63
Ex Tax: $185.63
MIDNITE, MNKID-B, MPPT CONTROL, CHARGE C
Comes standard with wall mounting bracket. Can be cut into the wall for a flush mount a..
$362.18
Ex Tax: $362.18
MIDNITE, MNKID-M-B, MPPT CONTROL, CHARGE
The Kid, a 30A Charge Controller, is made for small to medium sized renewable energy systems...
$411.68
Ex Tax: $411.68
MIDNITE, MNKID-M-BKT-B, KID MARINE MOUNT
Marine mounting bracket. Can be used with the MNKID or MNKID-M. Comes in black or white with knob..
$65.18
Ex Tax: $65.18
MIDNITE, MNKID-WMB-B, KID WALL MOUNT BRA
Wall mounting bracket for MNKID and MNKID-M. Available in black or white. To order in white us..
$20.63
Ex Tax: $20.63
MIDNITE, MNLP, CHARGE CONTROLLER INTERFA
MidNite Lite Panel for the Classic Lite MPPT Charge Controller   Size: 4.5"L x 3.75W..
$82.50
Ex Tax: $82.50
MIDNITE, MNNWC3, CONTROL NETWORK CABLE 3
3 foot cable for the MidNite network. Used to network MidNite products together.   ..
$4.95
Ex Tax: $4.95
MIDNITE, MNTCB, TURBINE CONTROL BOX AND
The MidNite Turbine control box contains over current protection, a 3 Phase stop switch and a qua..
$387.75
Ex Tax: $387.75
MIDNITE, MNWVJR, WHIZ BANG JR, SHUNT SEN
The Whiz Bang Jr is a current sense module that attaches to the standard 50mv / 500A Shunt and wi..
$48.68
Ex Tax: $48.68
Sign up for newsletter